New taps? We'll fit them properly.

Single-lever or twin-handle mixers. Deck-mounted (through sink) or wall-mounted. Pull-out spray heads for washing up. We fit them all.

Pillar taps (separate hot and cold), basin mixers, or mono-bloc single-hole mixers. We match tap centres to your basin holes.

Deck-mounted on the bath rim, wall-mounted for freestanding baths, or bath/shower mixers with diverter. We ensure correct hot and cold positioning.

For basins without tap holes or freestanding baths. Pipe connections are concealed in the wall. Trickier to install but look very clean.

We disconnect and remove old taps carefully. If fittings are seized, we cut them free without damaging the sink or basin.

We fit isolation valves on hot and cold supplies if there aren't any. This lets you turn off water to the tap for future maintenance without draining the system.

We mount taps properly with backnut and washers, seal with plumber's putty or silicone, and tighten securely so they don't work loose.

We connect flexible hoses to supplies (or rigid copper for wall-mounted taps), turn on water, check for leaks, and test hot/cold operation and flow.

No sealant under the tap base or the fixing isn't tight. Water seeps underneath and damages the worktop. We seal properly.

The backnut isn't tightened or there's no retaining plate on thin sinks. Taps move when you use them. We secure properly with top-hats or backing plates.

The tap holes don't match the tap centres. Pillar taps on basins designed for mono-bloc. We check compatibility before ordering.

Cheap hoses restrict flow. Kitchen taps especially need good flow. We use quality hoses with correct bore size.